Camtrol Video Camera Stabilizing Quadpod User Manual - page 8
9)
Wrap remaining Camtroller Cable around a pencil or Pen to coil as shown
10)
Feed into handle as shown, remove pencil and push coiled cable into handle.
Camtrol Video Camera Stabilizing Quadpod User’s Manual
Figure 5 Camtrol Cable Installation
7
E- Set Up Instructions For Installing Wired Remote
( Continued )
9 & 10. Excess
cable wrapped
on pencil
11)
Re-install handle top
12)
Re-install two screws.
13)
Decide which shooting configuration you want to use.
14)
Warning: Before setting up desired shooting configuration, turn all three VLBJs(Variable
Locking Ball Joints) ¼ turn to the left(counter clockwise) and insure they are loose.
Holding the Camtrol in your left hand, place the camera over the CMT(Camera Mounting
Thumbscrew) with your right hand, Mount camera on CMT(Camera Mounting
Thumbscrew) loosely and move camera on QPSP (Quad Pod Skid Plate) in the mounting
channels until camera feels it is properly balanced and centered. Fully tighten down all
three VLBJ(Variable Locking Ball Joints). When properly centered and balanced, the
Camera on the Camtrol will sit level to the ground and feel comfortable to the operator
.
15)
Adjust to your desired configuration.
16)
Launch and Have Fun!