Canarm DUAL MOUNT SERIES Installation Instructions Manual - page 4
Pg. #4
NOTE:
All set screws must be checked and
retightened where necessary, before and after
installation.
MOUNTING OPTION
CAUTION
Upper Jam
Screw
Upper Jam
Screw
Do not loosen two lower jam screws
Bolt
Yolk
Yolk
Flat Washer
Cotter
Pin
INST
INST
ALLA
ALLA
TION
TION
1.
Motor
Canopy
Yoke Screws
& Washers
Rubber Bushing
Canopy
Rubber
ring
Fig. 2a
Fig. 2b
Fig. 2c
Fig. 2d
Fig. 2e
Pg. #9
MOUNT BLADE BRACKETS TO BLADES
6.
- Place blade bracket screw through flat washer, fibre washer and blade.
- Align with corresponding hole in blade bracket.
- Repeat with (2) remaining screws and tighten.
DOWNROD MOUNT
- Using a Philips screwdriver loosen the two upper jam screws on the yoke.
- Position downrod inside canopy.
- Route wires exiting yoke on motor through ceiling canopy and downrod.
- Position downrod/canopy into yoke and align holes in yoke and downrod.
- Insert bolt through hole in yoke and downrod.
Be careful not to damage
or cut the fan wires.
- Tighten flat washer, lock washer, and nut and bolt (
not included on some
models). Secure with cotter pin through hole in the end of the bolt.
- Secure downrod in position by tightening upper jam screws.
A
FLUSH MOUNT
- Remove the yoke screws and lockwashers which correspond to the holes
- Optional for some models
-Remove rubber ring from canopy (see Fig. 2d)
in the canopy.
- Position canopy over the holes on motor and secure with the same screws
and lockwashers removed in the previous step. Ensure to place the rubber bushing
between the canopy and motor.
B
Blade
Bracket
Fibre Washer
Flat Washer
Fig. 8
Blade Bracket Screw