Canarm DUAL MOUNT SERIES Installation Instructions Manual - page 5
Pg. #8
Pg. #5
INSTALL MOUNTING BRACKET
- Install J-Hook through centre of outlet box and into the wooden joist.
- Secure mounting bracket and rubber gaskets to outlet box.
- Hang the safety cable onto the J-hook.
- Hang fan on temporary hook and install safety cable.
Canopy
Safety Cable
Temporary Hook
J-Hook
Ceiling
Wood Joist
Outlet Box
Rubber Gasket
Mounting Bracket
2.
Style#2
Fig. 3a
Fig. 3b
WARNING: To Reduce The Risk Of Fire, Electric Shock, Or Personal
Injury, Mount To UL/CSA Listed Outlet Box Marked Acceptable for
Fan Support And Use Mounting Screws Provided With The Outlet Box.
MOUNTING FAN ASSEMBLY
- Place two screws and washers on mounting plate (marked B on diagram)
which correspond with slots in canopy. Screw in two turns.
- Position canopy to mounting plate aligning slots to screws (marked B on
diagram) then turn to lock.
- Position and tighten the two screws and washers (marked A on diagram)
then tighten the two screws (marked B on diagram).
ENGAGE HEMISPHERE (Downrod Mount Only)
4.
5.
Outlet box Screws
(not provided)
3
3
.
.
ELECTRICAL HOOK-UP
- This fan is equipped with a remote control unit for controlling the fan
speeds and light kit.
A
Fig. 4
Setting the code on the hand-held remote and
the receiver.
- remove the battery cover on the hand-held
remote (Press firmly below the arrow and slide
the battery cover off).
- set code switches to desired position.
- set the code switches to the same positions on
the receiver as set on the remote.
- Carefully rotate fan assembly until groove in hemisphere locks over tab of
canopy assembly.
Downrod
Hemisphere
Groove
NOTE: When installing fan on sloped ceiling, make sure tab on hanger bracket
faces towards the top of the slope. Depending on the slope, a longer
downrod may be required to prevent fan blades from hitting the ceiling.
Fig. 7a
Fig. 7b
WARNING: Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
(A)
(B)
(B)
Washers
(A)