Cannondale LEFTY 2.0 Owner's Manual - Supermax/lefty 2.0
17
130920.PDF
2015 CANNNDALE TECH BOOK
37
HEADSHOK/LEFTY/SUPERMAX
© Cycling Sports Group, Inc.
Retailer Service: 1-800-245-3872, Retailer Fax: 1-203-846-6616
2015 CANNNDALE TECH BOOK 6/14
Illustrations are for part reference only, not assembly instructions.
All information is subject to change without notice.
SUPERMAX/LEFTY BRAKE LINE ROUTING
UPPER CLAMP
SUPERMAX - 45mm
LEFTY 2.0 - 43mm
LEFTY - 41mm
GUARD
LOWER CLAMP
SUPERMAX - 43mm
LEFTY 2.0 - 41mm
LEFTY - 41mm
GUIDE
YES
NO!
3mm
ZIP TIE
BRAKE LINE
BRAKE LINE
(to caliper)
(A)
Proper Brake line Routing
Align the upper and lower clamps so that the brake line
passes vertically through them to the the brake line
guide on the guard.
Make sure the brake line is saddled completed in the
brake line guide and secured/fixed firmly with the
cable tie.
To tighten the cable tie, use a cable guide tool If the tie
is too loose it will permit the brake line to move in the
guide.
Route the line as shown to the brake caliper.
Minimum Clamp Height - (A)
(from the top of the GUARD to the LOWER CLAMP)
To prevent the guard from contact with the brake line
clamp during movement, position the clamp according
to the table below.
SUPERMAX
(A)
Travel + 30mm
160mm/27.5
190mm
140mm/27.5
170mm
130mm/29
160mm
LEFTY 2.0
100mm/29
130mm
2015 CANNNDALE TECH BOOK
37
HEADSHOK/LEFTY/SUPERMAX
© Cycling Sports Group, Inc.
Retailer Service: 1-800-245-3872, Retailer Fax: 1-203-846-6616
2015 CANNNDALE TECH BOOK 6/14
Illustrations are for part reference only, not assembly instructions.
All information is subject to change without notice.
SUPERMAX/LEFTY BRAKE LINE ROUTING
UPPER CLAMP
SUPERMAX - 45mm
LEFTY 2.0 - 43mm
LEFTY - 41mm
GUARD
LOWER CLAMP
SUPERMAX - 43mm
LEFTY 2.0 - 41mm
LEFTY - 41mm
GUIDE
YES
NO!
3mm
ZIP TIE
BRAKE LINE
BRAKE LINE
(to caliper)
(A)
Proper Brake line Routing
Align the upper and lower clamps so that the brake line
passes vertically through them to the the brake line
guide on the guard.
Make sure the brake line is saddled completed in the
brake line guide and secured/fixed firmly with the
cable tie.
To tighten the cable tie, use a cable guide tool If the tie
is too loose it will permit the brake line to move in the
guide.
Route the line as shown to the brake caliper.
Minimum Clamp Height - (A)
(from the top of the GUARD to the LOWER CLAMP)
To prevent the guard from contact with the brake line
clamp during movement, position the clamp according
to the table below.
SUPERMAX
(A)
Travel + 30mm
160mm/27.5
190mm
140mm/27.5
170mm
130mm/29
160mm
LEFTY 2.0
100mm/29
130mm
17
NL
SUPERMAX/LEFTY 2.0
GUIDE DURITE FREIN
Geschikte route remleiding
Lijn de bovenste en onderste remleidingklem uit, zodat de
remkabel verticaal door de remkabelgeleider loopt.
Zorg ervoor dat de remkabel volledig in de remleidinggeleider zit
en goed vastgezet is met de klemkabel. Gebruik een klemkabel
om deze voldoende vast te zetten. Als deze te los zit kan de
remkabel bewegen in de geleider.
Geleid de kabel zoals onderstaand is weergegeven naar de
remklauw..
Minimale klemhoogte - (A)
(van de bovenzijde van de beschermkap tot de onderste klem).
Om te voorkomen dat de beschermkap in contact komt met
remkabelklem tijdens invering is het belangrijk om de klem te
monteren volgens onderstaande tabel.