Canon FAXPHONE L170 - B/W Laser - Copier Starter Manual - Load Paper
7
Load Paper
Load Paper
1
Pull out the cassette completely.
CAUTION
Be sure to completely remove the cassette from the
machine, and place on a flat surface before performing
the following steps. Failure to do so, may cause the
machine to tip over, and result in personal injury.
z
2
Pinch and slide the length slide guide to match the
paper size.
3
Pinch and slide the width slide guides to the size of
paper.
4
Fan the paper stack and even the edges.
5
Load the paper into the cassette.
NOTE
– Make sure the paper stack sits below the hooks (A).
– Make sure the stack height does not exceed the limit
mark (B).
6
Insert the cassette.
NOTE
– If you do not completely insert the cassette into the
machine, paper jams may occur.
– Do not load paper from the rear of the cassette.
7
If you use a paper size other than LTR, you will
have to change the paper size setting through the
control panel. (See Chapter 4, “Paper Handling,” in
the Basic Guide.)
To load Legal-size paper
1
Pull the tab (A) and extend the cassette (B).
2
Set the paper guide to LTR (A).
A
B
A
E x .
P A P E R S I Z E
A 4
A
B
A
8