Unpacking and assembly dynamic indoor rower.
Concept2.Com page 2 0914 concept2 dynamic indoor rower assembly instructions step 1. Open the two boxes and remove all the parts. Lay out the parts as shown below and read through the assembly instructions before beginning assembly. Note: the clear plastic shield located on the top of the flywheel i...
Concept2.Com page 3 0914 photo a step 2: attach rear foot to flywheel box photo c assembly instructions photo e concept2 dynamic indoor rower assembly (2) 3/8” (.95 cm) pn 2239 be sure that caster wheels point back, as shown in the photo of the assembled dynamic indoor rower on page 9. Install the t...
Concept2.Com page 4 0914 start all three 3/8” screws through the flange of the shuttle channel into the corresponding threaded holes in the return mechanism box. Do not fully tighten the screws until all three screws are in place. See photo f. Step 4: attach rail assembly to flywheel assembly note: ...
Concept2.Com page 5 0914 step 7: install rail assembly end stop (2) 1/2” (1.27 cm) pn 2226 (1) x rail assembly end stop w/2 nuts install the rail assembly end stop on the underside of the rail assembly. Be sure nuts are oriented down toward the floor. See photo k. Step 8: attach front leg/monitor ar...
Concept2.Com page 6 0914 assembly continued concept2 dynamic indoor rower photo q feed it all the way through the rail assembly until it comes out the other end. See photo p. Partially unwrap the white tape and wrap it around the generator cable plug, covering the plug. See photo q. Pull the black i...
Concept2.Com page 7 0914 assembly continued concept2 dynamic indoor rower at the opposite end of the machine where the shuttle channel meets the rear leg, reach into the slot in the shuttle channel and grasp the shuttle. Pull the shuttle up through the slot in the shuttle channel so that it is expos...
Concept2.Com page 8 0914 concept2 dynamic indoor rower step 11: install handle drive cord and front leg end cap (2) 1 3/8” (3.49 cm) pn 2228 run the handle with drive cord around the top pulley. See photo z. Pull the handle toward the foot carriage until it can be placed in the foot carriage handle ...
Concept2.Com page 9 0914 concept2 dynamic indoor rower additional notes setting the level of the dynamic indoor rower the dynamic indoor rower should be approximately level for the moving components to work properly. Use the front foot leveling screws to fine tune the level as follows: have a friend...
Concept2.Com page 10 0914 concept2 dynamic indoor rower front leg/ monitor arm assembly caster wheel foot carriage shuttle channel rail assembly flywheel front foot leveling screws wind shield.
