Concept2 Dynamic Unpacking And Assembly Instructions

Other manuals for Dynamic: Assembly manual
Manual is about: dynamic indoor rower

Summary of Dynamic

  • Page 1

    Unpacking and assembly.

  • Page 2

    Concept2.Com page 2 012611 concept2 dynamic indoor rower assembly instructions step 1. Open the two boxes and remove all the parts. Lay out the parts as shown below and read through the assembly instructions before beginning assembly. Foot carriage flywheel return assembly shuttle channel rail assem...

  • Page 3

    Concept2.Com page 3 012611 photo a step 2: attach rear foot to flywheel box assembly photo b assembly instructions photo d photo e concept2 dynamic indoor rower (2) 3/8” (.95 cm) pn 2239 be sure that caster wheels point back, as shown in the photo of the assembled dynamic indoor rower on page 8. Ins...

  • Page 4

    Concept2.Com page 4 012611 assembly continued start all three 3/8” screws through the flange of the shuttle channel into the corresponding threaded holes in the return mechanism box. Do not fully tighten the screws until all three screws are in place. See photo f. Step 4: attach rail assembly to fly...

  • Page 5

    Concept2.Com page 5 012611 pull the handle all the way out (away from the flywheel) so that the drive cord is stretched out straight in the shuttle channel. This action will cause the foot carriage to move toward the flywheel. See photo k. Again, be sure the drive cord going to the handle and foot s...

  • Page 6

    Concept2.Com page 6 012611 assembly continued concept2 dynamic indoor rower photo q generator generator cable photo r photo s step 9: install the generator cable uncoil the black installation leader tape by removing the blue tape. Do not remove the white tape on the end. At the back end of the shutt...

  • Page 7

    Concept2.Com page 7 012611 photo v assembly continued photo u photo w concept2 dynamic indoor rower top pulley foot carriage handle hook front leg end cap monitor arm front leg step 10: install handle drive cord and front leg end cap (2) 1 3/8” (3.49 cm) pn 2228 run the handle with drive cord around...

  • Page 8

    Concept2.Com page 8 012611 additional notes setting the level of the dynamic indoor rower the dynamic indoor rower should be approximately level for the moving components to work properly. Use the front foot leveling screws to fine tune the level as follows: have a friend watch you row: • if the sea...