- DL manuals
- CONCORD
- Fan
- Ponderosa 52PD
- Owner's Manual And Installation Instructions
CONCORD Ponderosa 52PD Owner's Manual And Installation Instructions
Summary of Ponderosa 52PD
Page 1
A commitment to excellence part number: pl-3243 ponderosa ™ owners manual and installation instructions ® 52pd.
Page 2
2 read and save these instructions before beginning installation of your new concord ® ceiling fan, read and follow these safety precautions. If you are not familiar with national and local electrical codes and basic electrical wiring procedures, we recommend that you have a qualified electrician in...
Page 3
3 this ceiling fan was not designed for installation in any location where it might be exposed to moisture or high humidity. Installation in this type of location could be unsafe, will most likely damage the fan and its finish... And will void your warranty. Every effort has been made to provide you...
Page 4
4 fig. 1 fig. 2 fig. 3 slotted holes junction box ceiling canopy mounting screw have you turned off the electricity? Loosen the two canopy mounting screws on the downside face of the mounting bracket. Back them out about half way. This will allow for easier installation of the ceiling canopy later (...
Page 5
5 fig. 4 fig. 5 loosen the set screws (2) in the support rod coupler located on the top center of the motor housing (see figure 5) until the inside channel is clear. Remove and save the safety screw from the coupler. Place the ceiling canopy face down (small end) over the support rod coupler on the ...
Page 6
6 fig. 6 notice the half ball on the end of the support rod is grooved down one side (see figure 6). This keyway fits over the small keyway pin on the inside of the mounting bracket and keeps the ceiling fan from spinning on the mounting bracket. Using your step ladder, lift the fan and place the ha...
Page 7
7 if you require or would like to use a different method of con- trolling your fan, refer to the optional electrical wiring procedures on page 11. Step 4 making the electrical connections to operate your ceiling fan with the pull chain(s) and switches mounted on your fan, follow the instructions bel...
Page 8
8 slide the ceiling canopy up into place over the ceiling mounting bracket. The two screws on the mounting bracket face should slip through the key hole slots in the canopy (see figure 11). Rotate the canopy slightly until the screw heads are in the small end of the key hole. Tighten both screws. St...
Page 9
9 switch housing mounting plate pre-installed blade to motor screws blade fig. 13 remove the large screws in the face of the motor. Discard any rubber blocks attached to these screws. The rubber blocks are installed at the factory to stabilize the motor during ship- ment. Select the correct mounting...
Page 10
10 back off (loosen) the three screws on the electrical housing mounting plate attached to the motor shaft (see figure 15). A color coded wire connector (female) is located inside the electrical switch housing (see figure 14), a male connector extends from the mounting plate. Align the colors on eac...
Page 11: Optional Wiring Diagrams
11 figure 16 illustrates the wiring used to control the fan with a wall switch plus an optional light fixture controlled at the fixture. Figure 17 illustrates the wiring used to control fan with the pull chain on the electrical switch housing plus an optional light fixture with a wall switch. Figure...
Page 12: Operation Instructions
12 © great 2000 enterprises, inc., 2005 • all rights reserved • no part of this publication may be produced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form by any means without the written permission of great 2000 enterprises, inc.. Concord fans a...