CONCORD Ponderosa 52PD Owner's Manual And Installation Instructions - page 4
4
Fig. 1
Fig. 2
Fig. 3
Slotted Holes
Junction Box
Ceiling Canopy Mounting Screw
Have you
TURNED OFF
the Electricity?
Loosen the two canopy mounting screws on the
downside face of the mounting bracket. Back
them out about half way. This will allow for
easier installation of the ceiling canopy later (see
figure 1).
Install the mounting bracket on the electrical
junction box in the ceiling using two machine
screws, two washers and two lock washers (see
figure 2).
The mounting bracket has slotted holes to enable
it to move sideways for proper alignment. Make
sure the mounting bracket is centered over the
electrical junction box and that it is securely
attached (see figure 3).
NO MOVEMENT SHOULD OCCUR
BETWEEN THE MOUNTING BRACKET
AND THE ELECTRICAL JUNCTION BOX.
Step 1 Attach the mounting bracket