Concox GPS Vehicle tracker User Manual - page 10
SMS command format:
GPRSSET#
Eg:GPRSSET#
Reply message:
GPRS:ON //GPRS on/off status//
APN:CMNET,0,0.0.0.0,,; //APN setting information//
Server:1,egt06.szdatasource.com,8841,0; //platform information//
URL:http://maps.google.com/maps?q=; //preset web link setting information //
5.10 GPRS time interval
The default GPRS time sending interval is 10s which means the device will
upload positioning data to the platform server every 10s. Users can modify
GPRS time sending interval by SMS “
TIMER,time(second)#
”.
The time ranges from 10-18000s
For example: TIMER,10#
It means the device will upload data to the server every 10s.
5.11 Sensor alarm time setting
When the vehicle power is off and ACC is in low-level, if ACC is off over 10
minutes, the device will enter sensor alarm state. In this case, if the vehicle
vibrates for a few times, it will activate the vibration alarm system. If the vehicle
battery is still not on (ACC is in low level) after 3 minutes, the device will start
vibration alarm.
SMS format: “
DEFENSE,TIME(minutes)#
” The time ranges from 1 to 60
mins.
For example: DEFENSE,15#. It means when ACC is in low level for 15mins, it
will enter sensor alarm status (vehicle power is off)
NOTE:
1. Preset SOS numbers when send SMS alarm messages and calls
2. If there is no need for vibration alarm, please SMS SENSOR,0# to close it.
5.12 Restore to factory setting
SMS comman
d format: “
FACTORY#
” to set all parameter to default factory
value. Once received “OK”, it succeeds.
5.13 Reboot device
When there is something wrong with the link of GPRS, e.g., The parameter
setting of the device is correct, but you can't track the car on the platform. At
this moment you can send a command to the device to reboot the device.
The format is:
RESET#
After receiving this command, the device will reboot after 1mins.