Concox GPS Vehicle tracker User Manual - page 12
When the electricity supply of device is cut off, it will activate cut-off alarm. In
this case, the device will send related SMS to the specific numbers and dial the
numbers in circles. If nobody answers, the call just keeps 3 loops at most. At
the meantime, the device will upload SOS alarm data to the server. And it will
send:
Cut Power!
http://maps.google.com/maps?q=N22576713,E113.916585
Note: The specific numbers should be preset, just refer to 6.4
6.5 Low battery alarm
When the device is only working with battery, once the internal voltage of
battery is less than 3.7V, device will send low battery alarm sms to specific
number and alarm on platform.
Low battery alarm sms content example: “Attention!!!battery too low, please
charge.” Which means the battery is to low, to inform user charging it in time.
Note: The specific numbers should be preset, just refer to 6.4
6.6 Vibration alarm
The vibration alarm function is off by default. To activate this function, please
send the following command: SENALM, ON#. The alarm will be sent to both
the service platform and SOS numbers.
When vehicle power is off, ACC status is low, and if the lead time of low ACC is
more than 10 minutes (settable)
, device will activate security alarm. When the
security alarm is on, once the vehicle vibrates for several times, the alarm will
be activated; in the next 3 minutes, if vehicle power is still off(ACC status is
low), device will start alarm. At this time, it will send alarm message to the
service platform with the latitude and longitude, while the platform will reply the
Chinese address. Then the terminal will send vibration alarm message to SOS
numbers with the Chinese address, and call the SOS numbers in cycle. If
nobody answers, it will stop calling after 3 loops.
If the Chinese address can not be acquired for certain reason, the terminal will
send a message with the website link to the SOS numbers.
e.g.:Sensor Alarm!,
http://maps.google.com/maps?q=N22576713,E113.916585
Note:
1.The SOS numbers should be preset.
2.Send “SENSOR, OFF#” to turn off the vibration alarm.
6.7 Voice monitoring
When the special number cell phone dial device, ringing for 10 seconds, it will