- DL manuals
- Conel
- Wireless Router
- ER75i v2 SL
- User Manual
Conel ER75i v2 SL User Manual - 5. Router Design
ROUTER DESCRIPTION
5
5. Router design
5.1. Version
Box
SIM1
SIM2
I/O
USB
PORT1 PORT2 ETH
ER75i v2B set
Plastic
ER75i v2B SL set Metal
ER75i v2F set
Plastic
ER75i v2F SL set Metal
Table 2: Router version
Fig. 2: Front panel ER75i v2B
Fig. 3: Front panel ER75i v2B SL
Fig. 4: Front panel ER75i v2F SL
Fig. 5: Front panel ER75i v2F SL
5.2. Delivery identification
Trade name
Type name
Other
ER75i v2B
ER-75i-v2
Basic version
ER75i v2B SL
ER-75i-v2
Basic version in the metal box
ER75i v2F
ER-75i-v2
Full version
ER75i v2F SL
ER-75i-v2
Full version in the metal box
Table 3: Delivery identification
Fig. 6: Label ER75i v2B
Fig. 7: Label ER75i v2F
Summary of ER75i v2 SL
Page 1
Edge router er75i v2 and er75i v2 sl user’s guide.
Page 2: Used Symbols
Used symbols conel s.R.O., sokolska 71, 562 04 usti nad orlici, czech republic manual issued in cz, 12/15/2011 ii used symbols danger – important notice, which may have an influence on the user’s safety or the function of the device. Attention – notice on possible problems, which can arise in specif...
Page 3: Contents
Contents iii contents 1. Safety instruction 1 2. Product disposal instructions 2 3. Router description 3 4. Contents of package 4 5. Router design 5 5.1. Version 5 5.2. Delivery identification 5 5.3. Ordering code 6 5.3.1. Basic version 6 5.3.2. Full version 6 5.4. Basic dimensions plastic box 7 5.5...
Page 4: Image List
Image list iv image list fig. 1: contents of package 4 fig. 2: front panel er75i v2b 5 fig. 3: front panel er75i v2b sl 5 fig. 4: front panel er75i v2f sl 5 fig. 5: front panel er75i v2f sl 5 fig. 6: label er75i v2b 5 fig. 7: label er75i v2f 5 fig. 8 basic dimensions plastic box 7 fig. 9: basic dime...
Page 5: Table List
Table list v table list table 1: expansion port possibilities 4 table 2: router version 5 table 3: delivery identification 5 table 4: ordering code of basic version 6 table 5: ordering code of full version 6 table 6: front panel description 10 table 7: router status indication 11 table 8: connection...
Page 6: 1. Safety Instruction
Safety instruction 1 1. Safety instruction please, observe the following instructions: • the router must be used in compliance with all applicable international and national laws and in compliance with any special restrictions regulating the utilization of the router in prescribed applications and e...
Page 7
Product disposal instructions 2 2. Product disposal instructions the weee (waste electrical and electronic equipment: 2002/96/ec) directive has been introduced to ensure that electrical/electronic products are recycled using the best available recovery techniques to minimize the impact on the enviro...
Page 8: 3. Router Description
Router description 3 3. Router description gprs/edge er75i v2 router is used to wirelessly connect various equipments and devices via ethernet interface 10/100 to the internet or intranet. Thanks to high security level and wide coverage of gprs/edge technology provided by mobile phone operators, it ...
Page 9: Contents of Package
Router description 4 4. Contents of package basic delivered set of router includes: • router, • power supply, • crossover utp cable, • external antenna, • clips for the din rail, • installation cd containing instructions, • paper start guide. Fig. 1: contents of package the router box and din mount ...
Page 10: 5. Router Design
Router description 5 5. Router design 5.1. Version box sim1 sim2 i/o usb port1 port2 eth er75i v2b set plastic er75i v2b sl set metal er75i v2f set plastic er75i v2f sl set metal table 2: router version fig. 2: front panel er75i v2b fig. 3: front panel er75i v2b sl fig. 4: front panel er75i v2f sl f...
Page 11
Router description 6 5.3. Ordering code 5.3.1. Basic version optional port ordering code version without optional port er75i v2b set version with optional ethernet port er75i v2b eth set version with optional rs232 port er75i v2b rs232 set version with optional rs485 port er75i v2b rs458 set version...
Page 12
Router description 7 5.4. Basic dimensions plastic box fig. 8 basic dimensions plastic box 5.5. Basic dimensions aluminum box fig. 9: basic dimensions metal box.
Page 13
Router description 8 5.6. Mechanical external dimensions and mounting recommendations mounting recommendations: • possibility to be put on a work surface, • din rail with clips cpd2 (elpac clip sl for sl version) are included. For the most of applications with a built-in router in a switch board it ...
Page 14
Router description 9 • for every cables we recommend to bind the bunch according to the following picture, we recommend for this use: length of the bunch (combination of power supply and data cables) can be maximum 1,5 m, if the length of data cables exceeds 1,5 m or in the event of, the cable leads...
Page 15
Router description 10 5.7. User interfaces (connectors) on the front panel is located: label connector description pwr 2-pin connector for connection the power supply adapter. Eth rj45 connector for connection into the local computer network. Port1 rj45 connector for connection equipment over rs232,...
Page 16
Router description 11 5.7.1. Status indication about router status inform eight led indicators on the front panel and on every port are two led indicators, which inform about port status. Label color state description pwr green blinking on router is ready starting of the router gsm red blinking comm...
Page 17
Router description 12 5.7.2. Power connector pwr panel socket 2-pin. Pin number signal mark description 1 vcc (+) positive pole of dc supply voltage (+10 to +30 vdc) 2 gnd (-) negative pole of dc supply voltage table 8: connection of power connector fig. 18: power connector power supply for router i...
Page 18
Router description 13 5.7.3. Antenna connector ant the antenna is connected to the router using the sma connector on the front panel. The router can not operate without the antenna connected labeled as ant. Example of antenna: fig. 21: external antenna the antenna with the sma connector. The antenna...
Page 19
Router description 14 5.7.4. Sim card reader the sim card reader for 3 v and 1.8 v sim cards is located on the front panel of the router. To initiate the router into operation it is necessary to insert an activated sim card with unblocked pin in the reader. The sim cards might be of different adjust...
Page 20
Router description 15 ethernet cable plug into the rj45 connector labeled as eth. (see bellow picture) fig. 25: connection ethernet cable the eth router connection: fig. 26: example of router connection.
Page 21
Router description 16 5.7.6. Port1 the port1 is equipped with one of the offered options ports. For port1 are available on the interface. Port1 rs232, rs485/422, ethernet, m-bus, cnt description, connection and examples of optional connection ports can be found in separate manuals expansion ports. P...
Page 22
Router description 17 5.7.8. Usb port panel socket usb-a. Pin number signal mark description data flow direction 1 +5v positive pole of 5v dc supply voltage 2 usb data - usb data signal – negative pole input/output 3 usb data + usb data signal – positive pole input/output 4 gnd negative pole of dc s...
Page 23
Router description 18 5.7.9. I/o port panel socket 3pin. Pin no. Signal mark description data flow direction 1 bin0 binary input input 2 gnd signal ground 3 out0 binary output output table 11: connection of i/o port fig. 32: i/o connector the user interface i/o is for processing of binary input sign...
Page 24
Router description 19 5.7.11. Reset it is important to distinguish between reset and reboot the router. Action router behavior invoking events disconnect and connect the power. Reboot turn off and then turn on router press the reboot button in the web configuration. Reset restore default configurati...
Page 25: 6. First Use
Router description 20 6. First use 6.1. Connecting the router before first use before you give up the router, it is necessary to connect all components needed for the operation of your applications and the sim card must be inserted. (see bellow picture) the router can not operate without connected a...
Page 26
Router description 21 6.2. Start router the router is set up connecting the power supply to the router. In the default setting the router starts to login automatically to the preset apn. Device on the ethernet port dhcp server will assign addresses. The behavior of the router can be modified by mean...
Page 27: 7. Technical Parameters
Technical parameters 22 7. Technical parameters 7.1. Technical parameters of router er75i v2 complies with standards en 301 511, v9.0.2 en etsi 301 489-1 v1.9.1 en 60950-1:06 ed.2 + a11:09 + a1:10 temperature range operation storage -30 c to +60 c o o -40 c to +85 c o o protection rating freely in s...
Page 28
Technical parameters 23 7.3. Technical parameters of processor 32b arm microprocessor memory 512mb ddr sdram 128mb flash 1mb mram interface serial interface rs232 ethernet interface 10/100mbit/s usb 2.0 interface table 15: technical parameters of processor 7.4. Technical parameters of i/o port port ...
Page 29: 8. Recommended Literature
Recommended literature 24 8. Recommended literature [1] conel: start guide, [2] conel: configuration manual, [3] conel: user’s manual - expansion port rs232, [4] conel: user’s manual - expansion port rs485/rs422, [5] conel: user’s manual - expansion port m-bus, [6] conel: user’s manual - expansion p...
Page 30: 10. Faq
Faq 25 ion in menu „external port“, or verify connection locally by the help telnet-hyper terminal. 10. Faq ¾ i can’t get from internet on equipment, which is connected to router and i have nat enabled. the device's gateway has to be configured as the router. ¾ router resets itself, connection on ...
Page 31
Faq 26 e, but the router is in online o offline mode by the sms message the router will be in this mode ¾ l2tp or ipsec isn’t establishing. verify the reason in the log system. ¾ i switched the router to offline mode by the sms messag mode after restart. control sms message doesn’t change the ro...
Page 32: 11. Customers Support
Customers support 27 11. Customers support up to date information about the product is on website: http://www.Conel.Cz/ upkeep-advices: the sim-card must be handled carefully as with a credit card. Do not bend, do not scratch on this and do not expose to static electricity. During cleaning of the ro...