1. DL manuals
  2. Conel
  3. Wireless Router
  4. LR77 v2 SL
  5. User Manual

Conel LR77 v2 SL User Manual

Other manuals for LR77 v2 SL: Configuration Manual, User Manual
Manual is about: v2 series

Summary of LR77 v2 SL

  • Page 1

    Lte router lr77 v2 libratum user’s manual.

  • Page 2

    Used symbols used symbols danger – important notice, which may have an influence on the user’s safety or the function of the device. Attention – notice on possible problems, which can arise in specific cases. Information, notice – information, which contains useful advice or special interest. Gpl li...

  • Page 3

    Contents contents 1 safety instruction 1 2 product disposal instructions 2 3 router description 3 4 contents of package 4 5 router design 5 5.1 router versions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 5.2 delivery identification . . . . . . . . . . . . . . . . . . . ...

  • Page 4

    Contents 10 faq 24 11 customers support 26 iii.

  • Page 5

    List of figures list of figures 1 contents of package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 2 lr77 v2 libratum . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 3 lr77 v2 libratum wifi . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5...

  • Page 6

    List of tables list of tables 1 router versions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 2 delivery identification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 3 front panel description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

  • Page 7

    1. Safety instruction 1. Safety instruction please, observe the following instructions: • the router must be used in compliance with all applicable international and national laws and in compliance with any special restrictions regulating the utilization of the router in prescribed applications and ...

  • Page 8

    2. Product disposal instructions 2. Product disposal instructions the weee (waste electrical and electronic equipment: 2002/96/ec) directive has been introduced to ensure that electrical/electronic products are recycled using the best available recovery techniques to minimize the impact on the envir...

  • Page 9

    3. Router description 3. Router description lte router lr77 v2 libratum is used to wireless connect various equipments and devices via ethernet interface 10/100 to the internet or intranet. Due to the high data transfer speed of up to 14.4 mbit/s (download) and up to 5.76 mbit/s (upload) is this rou...

  • Page 10

    4. Contents of package 4. Contents of package basic delivered set of router includes: • router, • power supply, • crossover utp cable, • two external antennas, • clip for the din rail, • paper start guide. Figure 1: contents of package 4.

  • Page 11

    5. Router design 5. Router design 5.1 router versions lr77 v2 libratum router is supplied in the following versions: box sim1 sim2 eth1 eth2 lr77 v2 libratum plastic lr77 v2 libratum sl metal lr77 v2 libratum wifi plastic lr77 v2 libratum wifi sl metal table 1: router versions figure 2: lr77 v2 libr...

  • Page 12

    5. Router design 5.2 delivery identification trade name type name other lr77 v2 libratum lr-77-v2l version in the plastic box lr77 v2 libratum sl lr-77-v2l version in the metal box lr77 v2 libratum wifi lr-77-v2l version with wifi module in the plastic box lr77 v2 libratum wifi sl lr-77-v2l version ...

  • Page 13

    5. Router design 5.4 basic dimensions of plastic box figure 7: basic dimensions of plastic box 5.5 basic dimensions of metal box figure 8: basic dimensions of metal box 7.

  • Page 14

    5. Router design 5.6 mechanical dimensions and mounting recommendations mounting recommendations: • possibility to be put on a work surface, • din rail with clips ckd2 (elpac clip sl for metal version) are included. For the most of applications with a built-in router in a switch board it is possible...

  • Page 15

    5. Router design • for every cables we recommend to bind the bunch according to the following picture, we recommend for this use: – length of the bunch (combination of power supply and data cables) can be max- imum 1.5 m. If the length of data cables exceeds 1.5 m or in the event of, the cable leads...

  • Page 16

    5. Router design 5.7 removing from the din rail default position of cpd2 holder (or ckd2 holder for sl version), which is used for mount- ing the router on a din rail, is shown in the following figure: figure 15: default position of din holder for removing from the din rail it is necessary to lightl...

  • Page 17

    5. Router design 5.8 description of the front panel on the front panel is located: caption connector description pwr 2-pin connector for the power supply adapter. Eth1 rj45 connector for connection into the local computer network. Eth2 rj45 connector for connection into the local computer network. A...

  • Page 18

    5. Router design 5.8.1 status indication about router status inform three led indicators on the front panel and on every eth port are two led indicators, which inform about port status. Caption color state description pwr green blinking on fast blinking router is ready starting of the router updatin...

  • Page 19

    5. Router design 5.8.2 power connector pwr panel socket 2-pin. Pin number signal mark description 1 vcc(+) positive pole of dc supply voltage (+10 to +30 v dc) 2 gnd(-) negative pole of dc supply voltage table 5: connection of power connector figure 19: power connector power supply for router is req...

  • Page 20

    5. Router design 5.8.3 antenna connector ant, div (and wifi) main and diversity antennas are connected to the router using the sma connector on the front panel. For lr77 v2 libratum with wifi module is also available reverse sma antenna connector, through which the wifi antenna can be connected. The...

  • Page 21

    5. Router design 5.8.4 sim card reader the sim card reader for 3 v and 1.8 v sim cards is located on the front panel of the router. To initiate the router into operation it is necessary to insert an activated sim card with un- blocked pin in the reader. The sim cards might be of different adjusted a...

  • Page 22

    5. Router design figure 25: ethernet connector attention! Port eth is not poe (power over ethernet) compatible! Ethernet cable plug into the rj45 connector labeled as eth (see figure below). Figure 26: connection of ethernet cable example of the eth router connection: figure 27: example of router co...

  • Page 23

    5. Router design 5.8.6 reset it is important to distinguish between reset and reboot the router. Action router behavior invoking events reboot turn off and then turn on router disconnect and connect the power, press the reboot button in the web configuration reset restore default configuration and r...

  • Page 24

    6. First use 6. First use 6.1 connecting the router before first use before you give up the router, it is necessary to connect all components needed for the operation of your applications and the sim card must be inserted (see figure below). The router can not operate without connected antenna, sim ...

  • Page 25

    6. First use 6.2 start the router is set up connecting the power supply to the router. In the default setting the router starts to login automatically to the preset apn. Device on the ethernet port dhcp server will assign addresses. The behavior of the router can be modified by means of the web or t...

  • Page 26

    7. Technical parameters 7. Technical parameters 7.1 technical parameters of router lr77 v2 libratum complies with standards en 301 511, v9.0.2, en 301 908-1 & -2: v3.2.1, etsi en 301 489-1 v1.8.1, en 60950-1:06 ed.2 + a11:09 + a1:10 temperature range function storage -40 ◦ c to +70 ◦ c -40 ◦ c to +8...

  • Page 27

    7. Technical parameters continued from previous page lte modul gprs/edge parameters edge bit rate 237 kbps (dl) / 237 kbps ∗ (ul) gprs bit rate 85.6 kbps (dl) / 85.6 kbps ∗ (ul) multislot class 12, cs 1 to 4, 3gpp rel. 99/4 standard support channels quad band lte: 800/900/1800/2600 mhz tri band umts...

  • Page 28

    8. Recommended literature 8. Recommended literature [1] conel: start guide, [2] conel: configuration manual, [3] conel: user’s manual – expansion port eth, [4] conel: application guide – programmer guide. 22.

  • Page 29

    9. Possible problems 9. Possible problems some network cards are able to be set in situation, when it is not possible to connect the router. It is possible to solve this problem in the following steps: • hand by selection communication rates 10 mb/s in property network cards, • connect router over s...

  • Page 30

    10. Faq 10. Faq - i can’t get from internet on equipment, which is connected to router and i have nat en- abled. • the device’s gateway has to be configured as the router. - router resets itself, connection on ethernet fails. • it is necessary to use an antenna, which will be situated far from power...

  • Page 31

    10. Faq • the operator doesn’t give out address dns servers and without dns server’s it is impossible to connect to server dyndns.Org. In log system will be this message: – dyndns daemon started – error resolving hostname: no such file or directory – connect to dyndns server failed - ipsec tunnel is...

  • Page 32

    11. Customers support 11. Customers support you can find current information about this product on our website: www.Conel.Com upkeep-advices: • the sim-card must be handled carefully as with a credit card. Don’t bend, don’t scratch on this and do not expose to static electricity. • during cleaning o...