Conlan CT2000 Master Manual - page 3
3
Adding user codes
1.
Enter the Master code and confirm by
pressing
. All 3 LEDs illuminates
for a moment, after which only the
green LED stays on.
2.
Enter a user number (00 - 99) and confirm by
pressing
. The yellow and the green LEDs
illuminates.
3.
Enter a code and confirm by pressing
.
The yellow LED illuminates alone.
4.
Repeat the code and confirm by pressing
.
If something went wrong, the red LED illumina-
tes shortly and you must go back to point 2.
If the entered code was correct, it is confirmed
by illumination of the green LED. The new user
code is now set.
5.
If you want to add more user codes, go back to
point 2. Press
if you wish to quit the program-
ming mode. All 3 LEDs illuminate for a moment,
afterwards only the LED which indicates normal
operation stays on. By default this is the yellow
LED.
Changing user codes
Is the same as adding new user codes. You just have to overwrite the positions.
1
3
5
7
9
2
4
6
8
0
#
1
3
5
7
9
2
4
6
8
0
#
Enter
Master code
#
user
number
#
1
3
5
7
9
2
4
6
8
0
#
Enter
user code
#
1
3
5
7
9
2
4
6
8
0
#
Repeat
user code
#
1
3
5
7
9
2
4
6
8
0
#
#
1
3
5
7
9
2
4
6
8
0
#
1
3
5
7
9
2
4
6
8
0
#