Connect Tech PSG013 User Manual - Software Interface
Connect Tech Xtreme/PSU-UC User Manual
Revision 0.00
16
Software Interface
The Xtreme/PSU-UC includes multiple interfaces for monitoring and control of the power outputs and
board temperature.
RS-232
The Xtreme/PSU-UC includes an on-board RS-232 port for monitoring and control of the power outputs.
The port runs at 57600 baud and a summary of the available commands are below.
Serial Command
Description
VER?
Display firmware version
HELP?
Display a list of available functions (from this table)
STARTUP=X
Startup power supply in specified number of seconds [X] (+12V, +5V)
SHUTDOWN=X
Shutdown power supply in specified number of seconds [X] (+12V, +5V)
TEMP0?
Display the temperature of Temp. Sensor 0 (°C)
TEMP1?
Display the temperature of Temp. Sensor 1 (°C)
USB
The Xtreme/PSU-UC includes an on-board USB port for monitoring and control of the power outputs and
board temperature. The USB port is an UART device, running at 57600 baud. Once connected, the RS-232
commands listed above also apply to this serial port connection. Drivers for the port can be found from our
website: www.connecttech.com/