Connect2Car ANYWHERE GSM KIT Installation Manual - Connect
Installation Manual
Connect
2
Car Anywhere GSM Kit
www.connect
2
car.com
23
Doors/Trunk/Hood/Ignition/Alarm siren. The disarm command is also activated anytime you send the
unlock command via the phone interface.
In essence this input synchronizes the Anywhere unit with your factory alarm system, incase you
disarm/arm the car with your local key fob unit when you are in range of the vehicle.
Connection:
The pin-10 (gray/ash) wire should be connected to the factory disarm output terminal or the disarm output
of an alarm system. Through this terminal, the device monitors the disarm state of the vehicle. This
terminal should not be left open.
Hint:
The factory disarm output wire should give a negative (+ve) pulse when the alarm/security unit is
disarmed. If it gives a -ve pulse, use relays/diodes to convert it to a positive pulse.
11.10. Yellow Wire (Pin8) Door, Hood and Trunk Trigger input (+ve):
This wire (yellow) is the Door, Hood and Trunk Trigger wire (+ve).
Connection:
The pin-8 (yellow) terminal should be connected to the door, hood and trunk switches. Through this
terminal, the device monitors all the doors of the vehicle as well as the hood and trunk. It senses when any
of them is open or closed. This is designed to sense +ve whenever any of the doors, hood or trunk is open. A
diode should be used to combine these wires if they are separated. A relay could also be used to reverse
the voltage from -ve to +ve if need be. This terminal should be left open if not used. You can use diodes as
shown to combine multiple input if needed. Use IN4002 Diodes which are available in most electronics
shops.
Figure 18 Diode isolating the input trigger connection
11.11. Black Wire (Pin6) the Alarm Trigger wire input (+ve)
:
This wire (black) is the Alarm Trigger input wire.
Connection:
The pin-6 (black) terminal should be connected to the “siren output terminal of the already installed and
working security and remote start device. Through this terminal, the device detects when the security
alarm is triggered and acts accordingly by sending an SMS alert to the designated user or users. This
terminal should be left open if not used.
Hint:
This wire is directly connected to the siren. It gives a 12V signal when the siren is
triggered and indicates ground voltage when the siren is stopped.
11.12.
Purple Wire
(Pin4) Battery level Monitor wire:
This wire (Purple) is the Battery Monitor wire as well as engine start detect wire.
Connection:
The pin-4 (Purple) terminal should be connected to the Positive 12v terminal of the battery. The device
monitors the battery level of the vehicle system through this terminal. 10secs after a remote start, the unit
monitors this wire for a voltage rise after engine start