D.A.S. Variant 18A User Manual - page 7
Manual del usuario/
User´s manual
28
C) AXW-V25
The AXW-V25 is made from stainless steel
and has been specially designed to wall mount up to 3
VARIANT 25A units. Six special M8x35 DIN912
screws must be used to attach the accessory to the
wall. The whole cluster can be tilted as in the AXC-
V25 accessory.
Pasadores
Quick release pins
Each flying point withstands 180 Kg with a 7:1 safety
ratio.
The maximum number of VARIANT 25A
units that can be flown from the AX-V25 bumper is 20
units with a 7:1 safety ratio. The maximum number of
VARIANT 18A units that can be flown from the AX-
V25 bumper are 6 units. Never exceed the maximum
number of units recommended.
2.3 SAFETY FACTORS
Variant series
2 x180 Kg (7:1)
4 x180 Kg (7:1)
D) Quick release pins
Each cabinet
includes 4 steel
heavy duty quick release pins stored on the rear panel.
Each cabinet
Both systems can be flown using
steel/aluminium rigging hardware located on both
sides of the cabinets. NEVER REPLACE QUICK
RELEASE PINS WITH SCREWS OR OTHER
ELEMENTS!!!
VARIANT 25A
VARIANT 18A includes 6 steel heavy
duty quick release pins stored on the rear panel.
E) Chain hoists
All units in a column will be flown from the
AX-V25 rigging grid (bumper), which should be used
with one hoist. The maximum load that can be flown
using the AX-V25 is 285 kg (627 lb) so one 0.5 Ton
hoist will be enough.
breaking load limit and the
maximum safe working load limit (SWLL). In this
case, the breaking load limit of each of the flying
points is 1250 kg (2750 lb) as determined by
destructive testing in independent laboratories. With
a 7:1 safety factor, a total amount of 20 units VARIANT
25A can be suspended from the AX-V25.
The safety factor is defined as the
coefficient between the