D'Alessandro Termomeccanica CS Small 100 Use And Maintenance Manual - page 7
7
1.5 Typographic Comventions
Special attention must be paid to the parts of this user guide marked with the symbols listed be-
low:
IMPORTANT
DANGER
MANDATORY
PROHIBITED
1.6 Guarantee and liability
The guarantee refers to both the mechanical and electrical parts of the generator, in compliance
with the European Directive 1999/44/EC, which protects the user against construction defects for
a period of two years.
The guarantee is void in case of damages due to:
Transport and/or handling (if charged to the customer);
Assembly errors by the installer;
Failure to comply with the maintenance and cleaning instructions described in this manual;
Failures and/or breaks not due to the malfunction of the machine itself;
Reasons not due to the manufacturer
The guarantee is valid only for the original customer and only when he/she becomes exclusive
owner of the machine.
Any controversy between D’Alessandro Termomeccanica and the purchaser are settled by arbi-
tration; in case of non-agreement upon the arbitration board, the place of jurisdiction shall be
Chieti. The aforementioned points are contained in the general conditions of sale, which are an
integrated part of the purchase agreement. Refer to the general conditions of sale also for cases
not mentioned in this document.
Guarantee or manufacturer liability cannot be called upon in case of damages to people and/or
objects due to:
Incorrect installation of the machine
Improper use of generator
Modifications to the generator
1.4 Reference standards
This manual has been written in compliance with the following Directives, Laws and Standards:
1. Directive 85/374/CEE on responsability for defective products
2. Directive 92/59/ CEE on General Safety of products
3. Directive 2006/42/CE on Machinery safety
4. Directive 2006/95/CE on electrical material safety
5. Directive 2004/108/CE on electromagnetic compatibility
6. Directive 89/106/CEE on manufacturing products
7. Technical standard UNI EN 12100-1/2 on machinery safety (Principals)
8. Technical standard UNI EN 1050 on machinery safety (
Principles for risk evaluation)
9. Technical standard CEI EN 60204-1 on machinery safety (Electrical equipment)
ATTENTION!
WARNING!
!