Summary of Z5560
Page 1
D z5560 manual 1.1 en.
Page 2
S y m b o l s o n t h e p r o d u c t p l e a s e r e f e r t o t h e i n f o r m a t i o n i n t h e m a n u a l . W a r n i n g ! D a n g e r o u s v o l t a g e ! General information z5560 manual version: 1.1 en, 12/2016, d2028.En .01 copyright © 2016 by d&b audiotechnik gmbh; all rights reserved...
Page 3
1. Z5560 d20 touring rack assembly cee................... 4 1.1. Intended use............................................................................ 4 1.2. Scope of supply...................................................................... 4 2. Handling, cooling and placement....................
Page 4
1.1. Intended use the z5560 d20 touring rack assembly is designed as a closed system rack providing mains power distribution and connector interfaces for 3 x d20 amplifiers. For this purpose, the touring rack is equipped with a mains power distribution device (x5565), which also serves as a loudspea...
Page 5
2.1. Handling the touring rack is equipped with two sliding doors allowing quick and easy access to the front and rear panels of the devices. 1. Unlock the door lock mechanism. 2. Open the door and ... 3. Push the door to the rear into its park position. 2.2. Cooling and placement when using the d&b...
Page 6
X5565 front panel 3.1. Intended use the x5565 mains power distributor is designed and dimensioned to provide and distribute the mains power supply necessary for the three d20 amplifiers. It also serves as a loudspeaker connection panel for different connection options. It is a protective class 1 uni...
Page 7
3.2.3. Mains link - 32 a cee the mains link socket allows further system racks to be linked to the mains power supply. Notice! To avoid any overload of the onsite mains power supply, we recommend you to link no more than two further system racks to the respective mains power supply line. 3.3. Front ...
Page 8
3.3.3. Amplifier mains supplies 16a three circuit -breaker are provided in conjunction with the three single-phase mains power lines (l1-l2-l3) of the respective amplifier. 3.3.4. 4 ch outputs - nl8 notice! The 4 ch outputs connectors are only intended as an interface to a rack panel or to loudspeak...
Page 9
4.1. Input the input section represents the input connectors of the first amplifier while the other two amplifiers are linked within the rack. The input section allows both analog and digital audio signals to be fed to the amplifier. 4.2. Input link the input link section represents the link output ...
Page 10
Can-bus network can represents the can input of the first amplifier while the other two amplifiers are linked within the rack. Can link represents the can output of the last (third) amplifier. Terminate/ link the built-in termination switch allows two settings: 1. Link: in system racks, at the start...
Page 11
The rack link cable allows further system racks to be linked together. It is suitable for both analog and digital audio signals as well as for network wiring (ethernet or can-bus networks). Technical specifications audio connector 2 x xlr female to 2 x xlr male with color markup audio signal capabil...
Page 12
D2028.En .01, 12/2016 © d&b audiotechnik gmbh www.Dbaudio.Com.