D&b Audiotechnik Z5560 Manual - page 8
3.3.3. AMPLIFIER MAINS SUPPLIES 16A
Three circuit -breaker are provided in conjunction with the three
single-phase mains power lines (L1-L2-L3) of the respective
amplifier.
3.3.4. 4 CH OUTPUTS - NL8
NOTICE!
The 4 CH OUTPUTS connectors are only intended as an interface
to a rack panel or to loudspeaker multicores such as d&b
Z5343.xxx and breakout adapters such as d&b Z5347.xxx.
Do not connect any loudspeaker cabinets, neither passive nor
active systems, to the 4 CH OUTPUTS connectors, otherwise there
is a risk of damaging the loudspeaker components or the amplifier.
Each of the 4 CH OUTPUTS connectors represents the 4
CHANNEL OUTPUT of the respective D20 amplifier. Each
connector carries the output signals of all four channels of the
amplifier with the following pin assignment.
Please refer to the corresponding channel assignment label above
each connector as shown in the graphic opposite.
d&b Z5560 Manual 1.1 en
8