D-CUT TA-070 Operation Manual - For Your Safety
to receive practical instruction before using the saw for the first time.
Always inspect cable and plug before using the saw. The outlet must
be grounded. Ground Fault Circuit Interrupter (GFCI) protection should
be provided on the circuit(s) or outlet(s) to be used for this saw.
Have damage repaired only by a qualified professional.
Do not use the saw in standing water or expose rain.
Wear hearing protection and safety goggles.
z
Always remove the plug from the power supply socket before removing
saw from work area, when interrupting work and when not using the
saw.
z
Insert the plug into the power socket only when the saw is
switched off.
z
Always place the cable away from the saw towards the outside
of the saw table.
z
Do not carry the saw by the cable.
z
Wear sturdy footwear.
z
Do not use the saw when the blade is not installed properly.
z
Always switch off the saw before lifting the table for cleaning.
z
Only use original D-Cut accessories.
z
Never leave the saw running unattended.
z
Keep guards in place. Adhere to safety guidelines: (ANSI)
American Safety Standards Institute.
z
Never stand or lean on equipment. Serious injury could occur
if the machine is tipped or is unintentionally contacted.
z
Do not over reach. Keep footing and balance at all times.
z
Disconnect tools. Before servicing, and when changing
accessories such as blades or profile tools. Turn off equipment!
z
Use the correct tools. Do not force the equipment or accessory
to do a job for which it was not designed
z
Use proper extension cord. Improper cord length and/or gauge
are the leading cause of premature electric motor failure! When
in doubt use heavier gauge cord.
FOR YOUR SAFETY
z
Cluttered areas and benches invite injuries
2