Operation manual d-cut laminate cutter xp-215 www.Dcutproducts.Com cutting and c.
2 the slot on the cutter base on the cutter base, there are a few sets of the slot used for the stopper attachment. Always use the slots closer to the pivot of the blade according to the width of the plank. The closer to the pivot of the blade, the more cutting power you will get. Free angle cut mar...
3 carry hook the chain to the ring on the handle and carry the cutter as shown. “l” cut when making an “l” cut, it is recommended to cut the lengthwise first, following the “lengthwise cut” procedure to cut plank to the required point and then re-position the plank, make a last cut “cut-out”. Length...
4 p a r t l i s t parts q’ty parts q’ty 1 steel teeth 2 14 supporting bar 2 2 working table 1 15 end cap 2 3 blade 1 16 base 1 4 customized bolt 1 17 chain 1 5 blade holder 1 18 hook b 1 6 solid rivet 4 19 rubber feet 5 7 rubber pad 1 20 blind rivet 5 8 handle 1 21 stopper attachment 1 9 hook a 1 22...
