D-CUT XP-215 Operating Manual - page 3
3
Carry
Hook the chain to the ring on the
handle and carry the cutter as shown.
“L” Cut
When making an “L” cut, it is
recommended to cut the lengthwise first,
following the “Lengthwise Cut” procedure
to cut plank to the required point and then
re-position the plank, make a last cut
“cut-out”.
Lengthwise Cut
When cutting laminate lengthwise, remove
the stopper from the cutter base. Mark a
line on the laminate plank and place it on
the base. Hold it down firmly while pushing
down the cutter blade. Small teeth located
along the cutting slot will keep the laminate
plank from slipping. If the cut is longer than
20cm (8 inch), it is recommended to make
a few cuts with the increment of 5cm (2
inch) for each cut in order to follow the
marked cutting line. After making each cut
pull the handle back up. Slide the cut
portion of laminate towards the pivot of
the blade and cut again. Repeat the
procedure until the full length of the cut is
completed.