D-Link AirPremier DWL-1750 Quick Installation Manual - page 4
4
Step 1:
With the unit powered off, attach the antenna to the antenna connector.
NOTE: Do not over-tighten; tightness by hand is sufficient. Position the antenna for
best signal reception.
Step 2:
Attach the Console Port cable to the Serial Port. Attach the other cable end
to the Serial Port on a PC running a terminal emulation program, and set the terminal
to 115200 Baud, No-Parity, 8 data bits, 1 Stop bit, and ANSI compatible. NOTE:
This connection is required only for setting up initial factory configuration information.
Step 3:
Plug the female end of the power cord into the Inline Power Injector, and
then plug the male end of the power cord into a power outlet or power strip. The
Power LED on the front of the Inline Power Injector will light up.
Step 4:
Run the Cross-Over Ethernet cable (included in your package) from the
Data Input Port (on the
front of the Inline Power Injector) to the Ethernet Port on the
PC
referenced to above.
Step 5:
Plug the
MIL-C-5015 style
Ethernet connector into the Special Ethernet port
on the back of the Router / Bridge.
Step 6:
Plug the RJ-45 Ethernet connector (the other end of the Special Ethernet
cable) into the Power & Data Output Port on the front of the Inline Power Injector.
When the Router / Bridge receives power over the Ethernet cable, the Router / Bridge
will start its boot sequence and the Active LED on the front of the Inline Power
Injector will light up.
Connecting The DWL-1750 Wireless
Connecting The DWL-1750 Wireless
Connecting The DWL-1750 Wireless
Connecting The DWL-1750 Wireless
Connecting The DWL-1750 Wireless
Router/Bridge To Your Network
Router/Bridge To Your Network
Router/Bridge To Your Network
Router/Bridge To Your Network
Router/Bridge To Your Network
1.
Special Ethernet port for connecting the MIL-C-5015 style Ethernet Cable
2.
Special serial port for connecting the MIL-C-5015 style RS-232 console port cable
3.
Reverse polarity-N Male connector for connecting an antenna or RF cable
4.
Power and Data output port for connecting another MIL-C-5015 style Ethernet cable
6.
AC power input port for connecting the power cord.
Please refer to the product image on pg. 5
5.
Data input port for connecting an Ethernet cable to a hub, switch, pc or router