D-Link DES-1026G User Manual - Connections
a Gigabit Ethernet network.
Off
When the LED light is off, the respective port is connected
to a 10/100Mbps Ethernet network, or no link.
Connections
Front Panel
10/100 Base-TX Twisted-Pair Ports
LED Indicators Giga Combo ports
10/100 BASE-TX Twisted-Pair Ports(Port1~24)
These ports support network speeds of either 10Mbps or 100Mbps,
and can operate in half- and full-duplex transfer modes. These ports
also support automatic MDI/MDIX crossover detection, giving true
“plug and play” capability. Just plug the network cable directly into
the hub; you can use either straight-through or crossover cable.
2*Combo GE Copper/SFP Ethernet ports
(Port25~26)
The DES-1026G is equipped with 2*Combo GE Copper/SFP
Ethernet ports that are auto negotiable 10/100/1000Mbps and also
support auto MDI/MDIX crossover detection. These two ports can
operate in half- and full-duplex modes. Furthermore, an SFP port can
also connect to servers and devices via fiber.
Rear Panel
AC Power Connector
This is a three-pronged connector that supports the power cord. Plug
in the female connector of the provided power cord into this
connector, and the male into a power outlet. Supported input
voltages range from 100~240V AC at 50~60Hz.