D-Link DES-3526 - Switch - Stackable User Manual - Ports
xStack
®
DES-3500 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
2
•
MAC Notification support
•
Asymmetric VLAN support
•
System and Port Utilization support
•
System Log Support
•
Address table: Supports up to 8K MAC addresses
per device
•
Supports 16M Bytes buffer memory per device
•
Supports Port-based VLAN Groups
•
Port Trunking with flexible load distribution and
fail-over function
•
IGMP Snooping support
•
SNMP support
•
Secure Sockets Layer (SSL) and Secure Shell
(SSH) support
•
Port Mirroring support
•
MIB support for:
•
RFC1213 MIB II
•
RFC1493 Bridge
•
RFC1757 RMON
•
RFC1643 Ether-like MIB
•
RFC2233 Interface MIB
•
Private MIB
•
RFC2674 for 802.1p
•
IEEE 802.1x MIB
•
RS-232 DCE console port for Switch
management
•
Provides parallel LED display for port status such
as link/act, speed, etc.
•
High performance switching engine performs forwarding and filtering at full wire speed, maximum 14, 881 packets/sec
on each 10Mbps Ethernet port, and maximum 148,810 packet/sec on 100Mbps Fast Ethernet port.
•
Full- and half-duplex for both 10Mbps and 100Mbps connections. Full duplex allows the switch port to simultaneously
transmit and receive data. It only works with connections to full-duplex-capable end stations and switches. Connections
to a hub must take place at half-duplex
•
Support broadcast storm filtering
•
Non-blocking store and forward switching scheme capability to support rate adaptation and protocol conversion
•
Supports by-port Egress/Ingress rate control.
•
Supports IP-MAC Port Binding.
•
Efficient self-learning and address recognition mechanism enables forwarding rate at wire speed
•
Safeguard Engine Support
Ports
•
Twenty-four (48 for the DES-3550) high-performance (MDI-X/MDI-II) ports for connecting to end stations, servers,
hubs and other networking devices.
•
All UTP ports can auto-negotiate between 10Mbps and 100Mbps, half-duplex and full duplex, and feature flow control.
•
Two 1000BASE-T Mini-GBIC combo ports for connecting to another switch, server, or network backbone.
•
RS-232 DCE Diagnostic port (console port) for setting up and managing the Switch via a connection to a console
terminal or PC using a terminal emulation program.
NOTE: For customers interested in D-View, D-Link Corporation's proprietary SNMP
management software, go to the D-Link Website (www.dlink.com) and download the
software and manual.