D-Link DES-6300 User Manual - Configuring Ports
Modular L3 Ethernet Switch User’s Guide
75
5. Click to apply the new data.
6. Close
the
Aggregated Sub VLANs Table Edit window.
To delete an Ethernet user-defined VLAN:
1. Display
theAggregated Sub VLANs Table.
2. Select an entry in the table.
3. Click . The entry is deleted.
4. Click to update the device.
Configuring Ports
Port Properties
Use the Port Properties window to define parameters for the port selected in the front panel
display or from the Select Port Number field in the Port Properties window.
Note:The Port Properties window can also be accessed by clicking
on the front panel
display toolbar, or by right-clicking the selected port, or by pressing Ctrl+T.
To display the Port Properties screen:
Select Device > Port > Port Properties. The Port Propertieswindow opens. The Port
Properties window has the following five tabs:
Main – Defines the general port settings including MAC address, port type, port
description, speed, administration status, port status, and full or half duplex modes.
Other – Defines the back-pressure and flow control modes.
VLAN – Defines the VLAN settings on a port.
IP – Displays the IP addresses and network masks for a selected port.
IPX – Displays the network addresses and network masks for a port
The default opening screen is the Main tab. The following paragraphs illustrate and describe
each screen tab.
The following figure illustrates the Port Parameters window Main tab.