D-Link DFL-260E Quick Installation Manual - page 6
6
To establish a console connection:
1. Plug the female end of the supplied
RJ-45-to-DB9 cable directly to the console
port on the Firewall, and tighten the captive
retaining screws.
2. Connect the other end of the cable to a
terminal or to the serial connector of a
computer running terminal emulation
software. Use the following settings for
terminal emulation software:
Baud rate: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
3. Once you have correctly set up the terminal,
switch on your device. A boot sequence will
appear on the terminal screen.
4. Once the boot sequence completes, the
command prompt is displayed, the device is
ready to be configured.
Finalizing the Configuration
After initial setup, please refer to the companion
publications found in PDF format on the
accompanying master CD for detailed instructions
on configuring the DFL-260E/860E.
D-Link NetDefend Firewall User Manual
This document describes the general operation
and control of the NetDefendOS firmware, D-Link’s
proprietary operating system that drives and
controls the NetDefend firewall.
The User Manual includes detailed instructions
regarding typical administrative tasks.
D-Link NetDefend Firewall Log Reference
Guide
This document describes all log messages that
might be generated by the NetDefendOS.
D-Link NetDefend Firewall CLI Reference
Guide
This document describes all available text-based
commands that can be used with the RJ-45-to-DB9
Console or SSH interface to configure the firewall.
Additional Information
In addition to the user manual, the Master CD also
includes many device configuration examples.
Additional help is available through D-Link
worldwide offices listed in the appendix of the User
Manual or online. To learn more about D-Link
security product products, please visit the website
http://security.dlink.com.tw.
For support, please
visit the website
http://support.dlink.com.tw
, which
will redirect you to your regional D-Link website.
Hardware Specifications
CPU: RISC Based IXP processor
Flash: 128MB
DDRAM: 256MB
Interface:
WAN interfaces with 10/100/1000 Mbps
Ethernet ports
Configurable DMZ interfaces with 10/100/1000
Mbps Ethernet ports
LAN interfaces with 10/100/1000 Mbps
Ethernet ports
Console: RJ-45 connector
Physical Environment
Power
12V / 2.5A Internal AC to DC Switching Power
Adaptor
Operation Temperature
0 – 40 ℃
Storage Temperature
-20 – 70 ℃
Operation and Storage Humidity
5%-95% non-condensing
Emission (EMI), Safety and other
certification
EMI: FCC Class A, CE Class A, C-Tick, VCCI
Safety: UL, LVD (EN60950-1)