D-Link DGS-1210/ME series User Manual - page 42
4 Configuration
DGS-1210 series Metro Ethernet Managed Switch User Manual
Configuration > VLAN Status
The VLAN Status page is for user to search the VLAN which has already existed on the Switch.
Figure 4.55 - Configuration > VLAN Status
Enter the VLAN ID or VLAN Name then click Find to show the existed VLAN.
Configuration > MAC-based VLAN Settings
The table is used to create MAC-based VLAN entries on the switch. A MAC address can be mapped to any
existing static VLAN and multiple MAC addresses can be mapped to the same VLAN. When a static MAC-
based VLAN entry is created for a user, the traffic from this user is able to be serviced under the specified
VLAN regardless of the authentication function operated on the port. Therefore each entry specifies a
relationship of a source MAC address with a VLAN.
Figure 4.56 - Configuration > VLAN Status
MAC Address: Specify the MAC address to be reauthenticated by entering it into the MAC Address field.
VID (1-4094) / VLAN Name: Enter the VID or VLAN name of a previously configured VLAN.
Configuration > GVRP Settings
The GVRP Settings page allows user to determine whether the Switch will share its VLAN configuration
information with other GARP VLAN Registration Protocol (GVRP) enabled switches. In addition, Ingress
Checking can be used to limit traffic by filtering incoming packets whose PVID does not match the PVID of
the port. Results can be seen in the table under the configuration settings, as seen below.
32