D-Link DGS-3120-24PC-SI Hardware Installation Manual - page 28
Other manuals for DGS-3120-24PC-SI:
Product Manual
Manual is about: Product Manual
of
71
xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Switch Hardware Installation Guide
20
The RPS can be mounted in a standard 19" rack. Use the following diagram to guide you.
Figure 2-12 Installing the DPS-900 into the equipment rack
CAUTION: Installing systems in a rack without the front and side stabilizers installed could cause the
rack to tip over, potentially resulting in bodily injury under certain circumstances. Therefore, always
install the stabilizers before installing components in the rack. After installing components in a rack, do
not pull more than one component out of the rack on its slide assemblies at one time. The weight of
more than one extended component could cause the rack to tip over and may result in injury.