D-Link DGS-3630 SERIES Hardware Installation Manual - Rear Panel Components
DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Hardware Installation Guide
14
LED
Description
This LED will be off when both console ports are not active.
Fan1, Fan2, Fan3
This LED will light solid green when the fan is operating normally.
This LED will light solid amber when the Switch is booting up or when a
diagnostics test is taking place.
This LED will blink amber when a fan fails.
This LED will be off when the fan is not receiving power.
USB
This LED will light solid green if a USB flash drive is plugged in.
This LED will blink green when the Switch is reading or writing data to and from
the USB drive.
This LED will be off when no USB drive is plugged into the USB port.
This LED will light solid red when a USB drive failure has been detected.
Port LEDs
This LED will light solid green when there is a connection to a 10 Gbps Ethernet
device on any of the ports.
This LED will light solid amber when there is a connection to a 100/1000 Mbps
Ethernet device on any of the RJ45 ports.
This LED will light solid amber when there is a connection to a 1 Gbps Ethernet
device on any of the SFP+ fiber ports.
This LED will blink when a port is active.
This LED will be off when there is no link or activity.
Refer to the
LED Indicators
section in the
Appendix A - Technical Specifications
for more LED information.
Rear Panel Components
The rear panel of the Switches in this series features a security lock, a GND, power supply module slots, and fan
module slots.
One AC power supply module
and
three fan modules
are included in the package for the Switch.
Any additional power supply module needs to be bought separately. This switch also supports the use of a DC power
supply module.
Figure 1-5 Rear panel view of the DXS-3400-24TC with an AC Power Supply
Figure 1-6 Rear Panel view of the DXS-3400-24TC with a DC Power Supply
Figure 1-7 Rear panel view of the DXS-3400-24SC with a AC Power Supply