D-Link DGS-3700-12 Hardware Installation Manual - Front-Panel Components
DGS-3700 Series Layer 2 Gigabit Ethernet Switch Hardware Installation Guide
4
NOTE:
The S FP c ombo p orts on t he S witch c annot be us ed s imultaneously with t he
corresponding 10 00BASE-T por ts. I f bot h por ts are in us e at t he s ame t ime, t he SFP
ports will t ake pr iority over t he c ombo por ts and r ender the 1 000BASE-T por ts
inoperable.
NOTE:
For c ustomers i nterested in D -View, D -Link C orporation's pr oprietary S NMP
management s oftware, g o t o t he D -Link Website ( www.dlink.com) and d ownload t he
software and manual.
Front-Panel Components
DGS-3700-12
•
Eight 10/100/1000BASE-T ports
•
Four Combo 1000BASE-T/SFP ports located to the right
•
One female DCE RS-232 DB-9 console port
•
One 10/100Base-Tx out of band management port
•
One RJ-45 alarm port
•
LEDs for AC Power, DC Power, Console, Management, Fan, Master, Link/Act/Speed for each port
•
Grounding post
•
Fan module
•
Power module consisting of the following components:
−
AC power connector (power cord provided, supports voltage 100~240 VAC at 50~60 Hz 1.5A Max)
−
AC power Switch
−
DC power connector (supports voltage 48VDC 1.6A Max)
−
DC power switch
CAUTION:
The handles on the power and fan modules should only be used to replace the modules in
the event of a hardware failure. Do not use the power module handle to lift the Switch.
Figure 1- 1. Front Panel View of the DGS-3700-12 switch