D-Link DIR-620 Quick Installation Manual - Wimax Wan Connection
DIR-620
Quick Installation Guide
Configuring Connection to the Internet
!
You should configure your WAN connection in accordance with data
provided by your
Internet service provider (ISP). Make sure that you
have obtained all necessary information prior to configuring your
connection. Otherwise contact your ISP.
WiMAX WAN Connection
1. If your operator specified an identifier for the WiMAX network, proceed
to the WiMAX / Information page, enter the required value in the SSID
field and click the Connect button.
2. Go to the Net / Connections page and click the Add button.
3. In the Physical layer section, select the USB-WIMAX value from the
Physical interface drop-down list.
4. In the General settings section, specify a name for your connection
(any name for easier identification) in the Name field and select the
IPoE value from the Connection Type drop-down list.
5. For Static IP connection: fill in the IP Address, Netmask, Gateway
IP Address, and Primary DNS server fields.
6. For Dynamic IP connection: select the Obtain an IP address
automatically and Obtain DNS server addresses automatically
checkboxes.
7. Click the Save button.
8. On the Net / Connections page, select the choice of the Default
gateway radio button corresponding to the new WiMAX WAN
connection.
11