D-Link DIR-803 Manual Configuration Manual - page 3
3
1.
Introduction
DIR 803 Router is deployed with Etisalat e-Life HSI service. This router (Firmware
Version Eth_1.00 & Eth_1.01) is certified for use with HSI Plug & Play Services.
Hence the router is connected to a trunk port on GPON ONT.
Trunk port on GPON ONT includes an untagged Mgmt. VLAN and a tagged HSI
Service VLAN.
2.
Internet Account Configuration
a.
Connect an Ethernet Cable into the HSI Trunk Port on the ONT, Plug the other
end of the Ethernet cable into the WAN Port of the Router.
b.
Power ON the router & connect a laptop to the LAN Port of the router using
another Ethernet cable.
c.
Verify the dynamic IP address & default gateway address on the laptop.
d.
Using an internet browser, browse the default gateway address of the laptop
to access the GUI of the router. If authentication is prompted; use admin as
Username & Password
e.
From the router GUI, Click on
TCP/IP Settings
and select
WAN Interface
.
f.
Choose WAN Access Type as
PPPoE
and enter the HSI
Username
&
Password
provided by Etisalat
g.
Verify
VLAN ID
in the PnP Sub Request, enter the same
VLAN ID
and click the
Apply changes
to save the configuration.
h.
v