D-Link DIS-300G Series Quick Installation Manual - Wall Mounting
Quick Installation Guide
3
Wall Mounting
Mounting steps:
1. Screw the wall-mount brackets with screws in the accessory kit.
< This graph is for all DIS-300G series >
Ethernet Interface (RJ45 Ethernet)
The switch provides two types of Ethernet interfaces: electrical (RJ45) and optical (SFP)
interfaces.
Connecting the Ethernet interface via RJ45:
● To connect the switch to a PC, use straight-through or cross-over Ethernet cables,
● To connect the switch to an Ethernet device, use UTP (Unshielded Twisted Pair)
or STP (Shielded Twisted Pair) Ethernet cables.
The pin assignment of RJ-45 connector is shown in the following figure and table.
Pin
Assignment
PoE Assignment
(for DIS-300G-8PSW/DIS-300G-
14PSW only)
1,2
T/Rx+,T/Rx-
Positive VPort
3,6
T/Rx+,T/Rx-
Negative VPort
4,5
T/Rx+,T/Rx-
X
7,8
T/Rx+,T/Rx-
X