D-Link DP-100+ Hardware User's Manual - External Features
DP-100 Multiprotocol Ethernet Print Server User’s Guide
Introduction
3
Windows-based setup and administration software, PS Admin, is supplied
with the DP-100, making configuration and management quick and easy.
The DP-100 also supports configuration and management via the
telnet
protocol for networks without Windows-compatible machines.
External Features
This section describes the externally visible features of the DP-100 print
server.
Port Connectors
The DP-100’s three printer ports are located on its rear panel. Two identical
parallel ports are labeled LPT1 and LPT2; the single serial port is labeled
COM. These printer ports are independently configurable using the PS
Admin program or the print server’s
telnet
interface. (See the Print Server
Administration User’s Guide for information about configuring the print
server’s ports.)
Figure 1 -2 Port Connectors