D-Link DP-100+ Hardware User's Manual - Network Cable Connectors
Other manuals for DP-100+:
User Manual
Manual is about: Multi-protocol Ethernet Print Server
of
32
4
Introduction
Network Cable Connectors
The DP-100 features two alternative network cable connectors for either
twisted-pair 10Base-T cabling (using an RJ-45 connector) or thin coaxial
10Base2 cabling (using a BNC connector). Both of these network cable
connectors are located on the DP-100’s right side panel.
DC Power Connector
The DC power input connector is located on the DP-100’s right side panel
and is labeled DC 12V.
Figure 1 -3 Print Server Right Side Panel
LED Indicators
The front panel of the DP-100 features five LED indicators:
Figure 1 -4 Front Panel LED Indicators
♦
Power/Tx
◊
Steady or flashing green confirms that the DP-100 is powered on.