D-Link DPR-1260 - RangeBooster G Multifunction Print Server Quick Install Manual - Wep Encryption
10
D-Link DPR-1260 Quick Install Guide
WEP Encryption
It is recommended to enable encryption on your wireless router before
your wireless print server. Please establish wireless connectivity
before enabling encryption. Your wireless signal may degrade when
enabling encryption due to the added overhead.
1.
Log into the web-based
configuration by opening a
web browser and entering
the IP address of the print
server (192.168.0.10).
Click on
Setup and then
Wireless Settings on the
left side.
2. Next to Security Mode,
select
WEP.
3. Next to Authentication, select
Shared Key.
4. Select either
64-bit or 128-bit encryption from the drop-down
menu next to WEP Encryption.
5. Next to Key Type, select either
Hex or ASCII.
Hex (recommended) - Letters A-F and numbers 0-9 are valid.
ASCII - All numbers and letters are valid.
6. Next to Key 1, enter a WEP key that you create. Make sure you
enter this key exactly on all your wireless devices. You may enter
up to 4 different keys.
7. Click
Save Settings to save your settings. If you are configuring
the router with a wireless adapter, you will lose connectivity until
you enable WEP on your adapter and enter the same WEP key
as you did on the router.