D-Link DSL-504T Configuration Manual

1

Modem Configuration Guide

Dlink DSL 504T  

Configuring in Layer2 PPPoE for Windows XP and 2000

CONTENTS

1. Network Configuration

2. Restore Router To Factory Defaults

3. Re-configure In Layer2 PPPoE

4. Optional

Please note: Some screen shots may differ due to different versions of 

firmware used. Please have your router powered on and connected directly 

to your PC via Ethernet cable before you begin

1. NETWORK CONFIGURATION

PPPoE connection does not require you to have an IP address or DNS 

settings manually encoded on your network card. PPPoE connection uses 

authentication to establish the Internet connection and its after doing this 

that your router is assigned an IP and DNS settings from TPG.

To begin, your PC needs to receive a private IP address from the router. 

Most ADSL routers have DHCP enabled by default that will take care of this.

To ensure your Network Card is ready for this please follow the following 

steps:

A.  Click on 

Start -> Settings -> Control Panel -> Network Connections

B.  Find your Network Card then right click on this and select 

Properties

C. Double click on 

Internet Protocol TCP/IP

Dlink DSL 504T