Documentation is also available on cd and the d-link website this document will guide you through the basic installation process for your new d-link wireless controller. Dwc-2000 quick installation guide wireless controller quick installation guide fan.
2 e n g li s h about this guide this guide gives step-by-step instructions for setting up your d-link dwc-2000 wireless controller. Please note that the model you have purchased may appear slightly different from those shown in the illustrations. The dwc-2000 wireless controller is a full- featured ...
3 e n g li s h led indicator color status description power/ status orange/ green solid orange power-on pro- cess in progress. Solid green power-on pro- cess complete. Blinking orange device has crashed and is in recovery mode. Light off the device is powered off. Fan green/ red solid green the fan ...
4 e n g li s h step 2 – installation you can mount the dwc-2000 into a stand- ard 19-inch equipment rack. To install the dwc-2000 into a rack: 1. Attach the mounting brackets to each side of the chassis as shown in figure 5 and secure them with the screws provided. Figure 5. Mounting brackets 2. Use...
5 e n g li s h initial configuration the wireless controller software is preinstalled on the dwc-2000. When the device is powered on, it is ready to be configured. It comes with a default factory configuration that allows you to connect to it, but you should configure the con- troller for your speci...
6 e n g li s h 3. Connect the wireless controller following the instructions in the “powering on the device” section in this guide. The boot sequence will be displayed on the terminal. 4. Once the boot sequence is completed, the command prompt will be displayed and the device is ready to be configur...
7 e n g li s h figure 14. Configure ap valid access point summary: enter the mac address of the ap you want to manage. Figure 15. Enter mac addresses 3. Save settings and connect - when the wlan connection setup wizard has been completed, click the connect button to save your settings and connect yo...
