D-Link DWL-8600AP User Manual - Dhcp C
D-Link Unified Access System
Software User Manual
12/10/09
Page 68
Network DHCP Client Options
Document
34CSFP6XXUWS-SWUM100-D7
•
If you change any of the network connection parameters, click Submit to apply the changes to the system. If you want
the switch to retain the new values across a power cycle, you must perform a save.
N
ETWORK
DHCP C
LIENT
O
PTIONS
Use the fields on this page to enable and configure vendor class identifier information that the DHCP client on the switch
sends to the DHCP server when it requests a lease.
To access this page, click LAN > Administration > Network DHCP Client Options.
Figure 18: DHCP Client Options
IPv6 Fields: These display when IPv6 is selected as the protocol.
IPv6 Mode
Enables or disables IPv6 mode on the interface.
IPv6 Prefix
If no IPv6 address displays, select Add and then enter an IPv6 prefix/length.
Select the EUI64 option if the last 64 bits are to be derived from the MAC address. For
example, you can enter 2001::/64 and select the EUI64 option to have the 64-bit
address calculated from the MAC address.
IPv6 Gateway
Enter the IPv6 gateway address (do not include a prefix).
Default Routers
Displays the address(es) entered in the IPv6 Gateway field.
Table 11: DHCP Client Option Fields
Field
Description
DHCP Vendor Class ID Mode
Specify whether to enable or disable the vendor class identifier mode.
DHCP Vendor Class ID String
Enter the text to add to DHCP requests as Option-60, which is the Vendor Class
Identifier option.
Table 10: Network Connectivity Fields (Cont.)
Field
Description