D-Link DWS-1008 Installation Manual - Confi Guration (Continued)
12
D-Link Systems, Inc.
DWS-1008 Install Guide
Confi guration
To run the quickstart command:
1. Attach a PC to the DWS-1008 switch’s serial console port. Use the following
modem settings: 9600 bps, 8 bits, 1 stop, no parity, hardware fl ow control
disabled.
2. Press
Enter three times, to display a username prompt (Username:), a
password prompt (Password:), and then a command prompt such as the
following:
DWS-1008-aabbcc>
Each switch has a unique system name that contains the model number and
the last half of the switch’s MAC address (aabbcc)
3. Access the enabled level (the confi guration level) of the CLI:
DWS-1008-aabbcc>
enable
4. Press
Enter at the Enter password prompt.
5. Type
quickstart. The command asks you a series of questions. You can
type
? for more help. To quit, press Ctrl+C.
One of the questions the script asks is the country code. For a list of valid
country codes, refer to the section “Appendix: Country of Operation”.
Another question the script asks is, “Do you wish to confi gure wireless?” If
you answer
y, the script goes on to ask you for SSID and user information,
for unencrypted and encrypted SSIDs. If you answer
n, the script generates
key pairs for SSH and the administrative users you entered, generates a self-
signed administrative certifi cate, and then ends.
Quickstart Example
This example confi gures the following parameters:
• System name: DWS-1008-Corp
• Country code (regulatory domain): US
• System IP address: 10.10.10.4, on IP interface
10.10.10.4 255.255.255.0