D-Link DXS-3600-EM-4QXS Hardware Installation Manual - Ports
DXS-3600-32S 10GbE Layer 2/3 Switch Hardware Installation Guide
10
Figure 2-4 Inserting SFP transceivers into the Switch’s SFP ports
The SFP+ ports also support other transceiver form factors like SFP, SFP+, and WDM transceivers. A complete list of
SFP/SFP+/WDM transceivers, compatible with this switch, can be found in the “Port Specifications” section in
Appendix A, at the end of this document.
Installing Power Modules into the Power Module
Ports
The power module slots, located on the rear panel of this switch, support two types of power supply modules.
AC Power Supply Module:
• DXS-3600-PWR-FB: A 300W AC power supply tray with front-to-back air-flow.
• DXS-3600-PWR-BF: A 300W AC power supply tray with back-to-front air-flow.
DC Power Supply Module:
• DXS-3600-PWRDC-FB: A 300W DC power supply tray with front-to-back air-flow.
• DXS-3600-PWRDC-BF: A 300W DC power supply tray with back-to-front air-flow.
Installing an AC Power Module
Connect the one end of the AC power cord supplied to the AC power connector and the other end into a properly
grounded electrical outlet. The switch will automatically adjust the AC power setting to adapt to any voltage supply in
the range from 100~240VAC at 50~60Hz.