D-Parts B-Speech Tx2 User Manual - The Pairing Process
GB
- 16 -
The pairing process
1. Before pairing, please check that both devices are fully
charged.
2. Check that both devices are within 3 meters of each
other.
3. Turn the Bluetooth receiver on and make sure it is in
pairing mode. (If in doubt, read your receiver user guide).
4. Turn the TX2 on by pressing the On / Off button. The red
and blue LED flashes alternating for 6 seconds; the TX2
is in pairing mode.
5. Both devices should now find each other and pair. The
red and blue LED on the TX2 flashes slowly at same time
when the pairing is successful.
Turning B-Speech® TX2 on / off
Normally, both devices only need turning on after the
pairing; everything else is done automatically.
Turning on: The B-Speech® TX2 is turned on by pressing
on the On / Off button. The blue LED lights up.
Turning off: Press the On / Off button for about 5 seconds;
the blue LED goes off.
Note: Read the user guide of your Bluetooth receiver to find
out how to turn it on / off.