D&R AIRMATE-USB Manual - page 13
TALKBACK
By pushing the TB switch on the Hybrid module, the internal talkback microphone is activated and allows you to
talk to the caller without being ON-Air.
AUX SEND
Below the TB switch is the stereo Aux send that can be set to send stereo source signals pre or post fader (pre or
post jumper settings on the circuit board). The factory default is post fader.
RING (LED)
This LED lights to alert you when a call comes in.
CUE
Next you will see the stereo CUE switch (Pre Fader Listening). This switch allows you to check the signal before
you mix it with your other channel signals in the mixer.
ON
The ON switch is used to activate the module and generate a signal to start turntables, CD players, and cart or
jingle machines. This switch sends out a momentary pulse or switches continuously to the Start connector on the
back of the console. When used on either of the Hybrid modules, any other function needed can be activated.
FADER
Final control of the signal in either of these modules is the 100mm channel fader. With the fader you can send the
amount of signal from this module to be mixed with the other signals feeding the outputs whether the need is live
streaming or recording for production. At the beginning of the fader movement you will feel the internally built in
start switch that is activated when you bring up the fader. This switch activates the start circuitry which can control
externally connected (via the Start Connector on the back) devices such as CD players, turntables, etc.
INPUT CONNECTORS
On the back of each of the AIRMATE-TELCO modules 7 and 8 you find five connectors.
Two unbalanced stereo line RCA Cinch connectors for connecting
CD players, iPods, or any play-back devices as long as they are line
level equipment.
The level can be set using the gain control to match most source
levels.
The left RCA Cinch connector is the left input and the right RCA
Cinch connector is the right input. The shield is to be connected to
the ground or case of the RCA Cinch connector.
The START switch has two active connections to be wired. The
tip and ring are shorted when the ON switch or fader switch is acti-
vated.
Once you have done this, you can start the turntable with the ON
(if connected to the START connector) switch on the back panel.
These switches quick start turntables through the remote jack by a
continuous contact action at the back of the mixer. If your turnta-
ble only needs a pulse to start ask your dealer to modify the inter-
nal circuitry to change it into a momentary action, so you can use it
as a pulse start switch.
*NEVER CONNECT ELECTRICAL POWER TO THIS REMOTE-
JACK*
Connections on the START connector should only be made with a maximum of 24 Volts by 50 mA.
Please contact your dealer in case of doubt.
The two RJ11 connectors connect the Module to the telephone utility companies phone line connection (Wall) and
to your telephone appliance (Phone) so you can dial-out to people you want to interview or your radio program lis-
teners.