• h 2 o 1810 plus • h 2 o 1820 plus • h 2 o 1830 plus • h 2 o 1850 plus h 2 o plus series electronic dog trainer owner’s manual.
2.
3 table of contents • table of contents ....................................... 3 • introduction................................................. 4 • package contents ...................................... 5 • model features........................................... 6 • parts & functions .............
4 congratulations and thank you for purchasing our h 2 o plus series tm training collar with “add-on” capability. It offers the maxx-range™ internal antenna system, the industry’s only internally woven antenna in the collar. With up to a one mile range, they are perfect for hunting, basic obedience,...
5 important note: please read this owner’s manual in its entirety before operating this unit. Should you have any questions about our collars or their operation please contact our customer service department (see back page for address and phone number information). Package contents • transmitter • c...
6 model features h 2 o plus series • digital technology • up to one mile range • expandable to 2- or 3-dog* system with h 2 o add- on collar units (sold separately) • lightweight, waterproof collar and transmitter • no-slip/soft-grip transmitter floats on water! • 16 adjustable intensity levels of m...
7 transmitter parts & functions button #2* (function varies according to model) battery charging receptacle intensity dial collar selecting switch momentary ‘nick’ stimulation continuous stimulation red led indicator light button #1* (function varies according to model) *the h 2 o 1810 plus will not...
8 parts & functions beeper wire* collar receiver transmitter indicator light when one of the buttons on the transmitter is pushed, the red led light will turn on to indicate that the transmitter is being operated. When the battery needs charging, the red led light will blink rapidly after pressing a...
9 transmitter antenna be sure to check that the antenna is securely fastened to the transmitter before each use. Hand tighten only. Use care when attaching antenna. Over-tightening may cause damage to the antenna or antenna mount. Momentary and continuous stimulations pressing the upper button will ...
10 rise button (h 2 o 1830 plus only) pressing the button on the right (#2) of the transmitter will make the collar give a stimulation that gradually increases in intensity level the longer the ‘rise’ button is pressed. Locate and run/point buttons (h 2 o 1850 plus only) pressing the ‘locate’ button...
11 parts & functions beeper horn (h 2 o 1850 plus only) the beeper horn is attached to the collar belt. It will emit a loud tone audible from up to 450 yards away. Caution if your collar belt is too long , we recommend looping the excess collar belt back around through the buckle. We do not recommen...
12 charging the batteries all h 2 o plus series tm units are equipped with rechargeable nickel metal hydride (nimh) batteries. Nimh batteries are not memory sensitive and do not require depletion before recharging. The batteries come partially charged from the factory. However, it is recommended tha...
13 turning on and off the transmitter is always in a permanent sleep state. It is only on when a button is being pressed and does not need to be turned off by the user. Turning the collar unit on: press and hold the on/off button. The red led indicator will light solid for a second. Release the butt...
14 to test the vibration: (h 2 o 1820 plus only) a) press the button on the left side of the transmitter (vibrate button) and the collar unit will vibrate only. B) press the button on the right side of the transmitter (vib.+stim. Button) and the unit will vibrate only for 1/2 a second. The tester wi...
15 testing to test the beeper: (h 2 o 1850 plus only) a) press the button located on the left side of the transmitter (locate button). The collar will beep any time this button is pressed. B) press the button on the right side of the transmitter (run/point button) to activate the run & point mode. P...
16 programming the collar when adding an “add-on” collar, the collar will need to be programmed to the transmitter. If your current collar unit is not responding to the transmitter, it may also need to be reprogrammed to the transmitter. 1. Select the desired collar selecting switch position on the ...
17 properly fitting the collar note: proper collar tightness and position are very important to insure safe and consistent collar use. All electronic collars need to be very snug around the dog’s neck to work properly. They must be just tight enough to allow the “contacts” or electrodes to make good...
18 it is very important to set the correct intensity level on your h 2 o plus training system before beginning your training sessions to provide the proper level of stimulation without over-stimulating your dog. To do this, place the intensity selection dial so that the system is set on level 1. Tur...
19 setting the intensity level jump stimulation is a great feature when regularly us- ing two different stimulation levels in training. It is also a great safety tool for emergency situations when your dog is excited and cannot feel or ignores the normal intensity level. Pressing the jump button dir...
20 maintenance it is very important to periodically clean your h 2 o plus series tm systems for maximum performance. Regular cleaning will also lengthen the life of your unit. • clean the h 2 o plus series tm collar box with lukewarm water and a mild anti-bacterial soap. • take care to thoroughly cl...
21 important safety notes • before training, your dog should be examined by a veterinarian to assure that your dog is in good health. • never leave your dog unattended with the unit on. Since no electronic device is perfect, there is a very slight possibility that your dog may receive an unintention...
22 warranty d.T. Systems premium lifetime warranty is the best warranty offered in the industry. This warranty is free to participating u.S. Customers (a completed warranty registration card must be returned within 30 days of original purchase). This changes our normal one year parts and labor warra...
23 fcc compliance your h 2 o plus series tm has been manufactured under complete compliance with the federal communication commission (fcc). The complex internal structure of each product has been designed to operate within specific regulations of fcc specifications. Any unauthorized modifications t...
24 2872 walnut hill lane dallas, texas 75229 tel: (214) 350-9446, (888) 588-8364 fax: (214) 350-7847 website: www.Dtsystems.Com e-mail: customerservice@dtsystems.Com 1-h 2 o plus 2009.09.16 printed in korea.