D.T.Systems Super Trainer EZT plus Series Owner's Manual - page 10
10
Intensity Selection Dial
The intensity selection dial allows
you to choose between sixteen
different levels of stimulation,
allowing for very precise control.
PARTS & FUNCTIONS CONT.
The first and most important step in training your dog
with your EZT Training System is determining the
correct Intensity Level to provide the proper training
stimulation without over-shocking your dog.
To do this place the Collar on the dog’s neck and turn
it on. Place the Intensity Selection dial so that the
System is set on Level One. Press either the ‘NICK’
or the ‘STIMU’ Button. Increase the Intensity Level in
increments of one until the dog is feeling the
stimulation. You should be able to tell when the dog is
feeling the shock by the outward signs of discomfort or
confusion on it’s face. At this point, increase the
Intensity Level by one or two. This should be your
dog’s ideal training level. (Note: Some dog’s may
require more or less stimulation depending upon their
individual nature or size.)
TRAINING INTENSITY LEVEL
11
Transmitter Indicator Light
When one of the push button switches on the
transmitter are pushed, the RED light will turn on to
indicate that the transmitter is being operated. When
the battery needs charging the RED light will blink
once every 1/2 second while pushing a button.
Two Dog Model Selection Switch
(EZT plus 5002)
Switching between units can be controlled by moving
the toggle selection switch to the desired unit.
PARTS & FUNCTIONS CONT.
Transmitter Antenna
Be very careful when screwing the 4” antenna into the
transmitter. Hand tighten only. Over tightening could
cause damage to the antenna or the antenna mount.
Remote Training Buttons
Pressing the upper button causes the collar to
administer a Momentary Stimulation or ‘Nick’.
Pressing the lower button gives the Continuous
Stimulation.
Locate and Run/Point Buttons
Pressing the ‘Locate’ button on the left side of the
Transmitter will make the Collar Receiver beep.
Pressing the ‘Run/Point’ button on the right side of the
Transmitter will activate the Run/Point mode on the
Collar Receiver. Press it again and it will go into the
Point only mode. Press the ‘Locate’ button to cancel
the Run/Point modes.