D.T.Systems Super Trainer EZT plus Series Owner's Manual - page 9
12
PARTS & FUNCTIONS CONT.
Beeper Horn
The Beeper horn is attached to the collar belt. It will
emit a loud tone audible from up to 450 yards away.
CAUTION
Do not cut the collar belt.
Doing so will damage the antenna and may result in
severely decreased receiver range.
Collar Indicator Light
When the Collar Receiver is turned on, the RED light
will flash steadily once every two seconds to indicate
that the unit is active. The RED light changes to a
rapid flash (twice per second) when the battery is low
and in need of charging.
Electrodes
Electrodes should fit snugly on the dog’s neck to
ensure good contact with the skin. For more
information on the proper fit of the collar, see page 7.
Battery Charging Receptacles
The battery charging receptacle is located on the side
of the Transmitter, and on the side of the Collar
Receiver facing the dog’s neck. After charging,
always close the jack with the rubber plug to prevent
foreign particles from getting inside the unit.
Collar Belt with Embedded Receiver Antenna
The embedded collar antenna is woven into the collar
belt, and runs the along the entire length of the belt.
9
TURNING ON AND OFF
Turning the Unit On:
Press and hold the On/Off button on the Collar Receiver.
The Red LED Indicator will light solidly for two seconds.
Continue holding the Button until the Red light goes off.
The unit is now On. The LED Indicator will now flash
approximately every two seconds. (Note: The
Transmitter is always in a permanent sleep state. It is
only On when a button is being pressed, and does not
need to be turned off by the user).
Turning the Unit Off:
When you are ready to shut the unit off, simply press and
hold the On/Off button for three seconds. The Red LED
indicator will again light solidly for two seconds. Hold the
Button until the light goes off. The Unit is now Off.
PARTS & FUNCTIONS - COLLAR
Collar Receiver