Instruction book for advantage ® deluxe electrol ®.
2 1. The case provides multiple attachment points for bolts, cables, or threaded rod. Page 8 shows threaded rod installed. The variable position-mounting bracket may be located anywhere along the length of the case. It is recommended to keep the brackets spaced evenly enough to distribute the weight...
3 screen and roller assembly installation if your screen was shipped with the motor and roller already installed proceed to step 6. 1. Remove the screw from each end of the access door (front door) and open the door. See figure 1. 2. Carefully unpack screen and roller assembly. Leave packing paper o...
4 screen adjustment note: use a screw driver or 5/32" allen wrench to make adjustments. More screen drop 1. Place operating switch in “down” position. 2. When the screen stops, turn the white “down” limit knob (fig. 2) one-quarter turn counterclockwise. Test by raising picture surface approximately ...
5 advantage ® deluxe electrol ® instructions for standard control 220/240v wiring diagram 120v wiring diagram screen motor screen motor black (down) red (up) r ed (up) black (down) black (do wn) white (common) white (common) optional rf or ir remote connector optional rf or ir remote connector white...
6 not used not used advantage ® deluxe electrol ® instructions scb-100 control brown (hot) green / yellow (ground) blue (common) power input 240vac/50hz down stop up back of front of wall switch wall switch screen motor door motor terminal block tx - data out g - ground rx - data in tx - data out g ...
7 not used not used advantage ® deluxe electrol ® instructions scb-200 control blue (common) black (down) brown (down) green / yellow (ground) 120v wiring diagram power input and control board are located on right side of screen housing. 220/240v wiring diagram power input and control board are loca...
8 advantage ® deluxe electrol ® installation see detail a (suggested) 3/8" threaded rod (not included) 4.59" detail a hanger bracket flat bar mounting method formed bracket mounting method case length variable position mounting brackets 7 1/4" 7 1/4" 6 1/8" motor end electrical junction box 61 /8" (...
9 troubleshooting visit www.Da-lite.Com to find installation and troubleshooting tutorials. You will also find a link to live chat for interactive support and you can contact us by email at info@da-lite.Com or by phone at (800) 622-3737 or (574) 267-8101 with any troubleshooting questions. Symptom c...
10 troubleshooting symptom cause solution door will not open. Hinge is bound or has a foreign substance on it which does not allow it to open by gravity. Check installation to free door. Clear any foreign substance; i.E., paint or plaster from hinge. No power. See above. Door does not close. Open do...
11.
Limited one year warranty on da-lite presentation products milestone av technologies llc warrants certain da-lite branded products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; pr...
