Instruction book for designer contour ® electrol ®.
2 important safety instructions when using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3. If an exte...
3 installation carefully unpack screen and remove outer wrapping from case. Remove the black tape from the slat bar after the case has been installed. There are three ways to install the designer contour electrol: wall mount, ceiling mount, or ceiling hook. Procedures for each method are as follows:...
4 electrical installation internal wiring has been completed at the factory. Installer must route power to the wall switch and to the junction box located on the left end of the screen case. Standard installation is for a single 120vac or 240vac wall switch to control the screen. Optional control un...
5 electrical installation eye a u x low-voltage wall switch optional rf or ir remote connector motor white (common) black (hot) green ground to case red black white (common) black (up) brown (down) blue (common) 120vac 60hz 120v wiring diagram with optional built-in low voltage control black white r...
6 screen adjustment screen travel is stopped automatically in the down and up positions by the limit switches that are preset at the factory. If it’s necessary to adjust for more or less drop follow the steps below. The case cover must be removed to access the motor limit switches. Remove the case c...
7 troubleshooting symptom cause solution screen will not operate. Motor does not hum. Incorrect line voltage. Verify 115-125v (or 220-240v). If insufficient voltage, rewire incoming electric line. Blown fuse. Replace fuse. Tripped circuit breaker. Reset circuit breaker. No power to operating switch ...
Limited one year warranty on da-lite presentation products milestone av technologies llc warrants certain da-lite branded products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; pr...
